PLEASE NOTE: These tuning tires will look much smaller than the Carrera stock tires you are replacing (in some cases you may even be able to fit the tuning tire, inside the stock tire). Some tuning tires may fit multiple wheels, these tires are made to stretch so Paul doesn�t need to have a separate tire available for each type of car.
When installing you will need to stretch the tuning tire over the wheel.. To avoid damage to the car, or wheel, we have found it is easiest to take the chassis off by removing the 4 bottom screws prior to installation.
Dimensions: 20x12x5mm
This is a great performance tire for the following 1/32 Carrera models:
Chevrolet Camaro (newer body style)
Mustang GT
AMG DTM
Audi A4 DTM
Audi R10
Audi R8
Ferrari 599xx
Ferrari 575
Ferrari 458 Street Versions
Corvette C6R
Mercedes SLR
Mercedes SLS
Maserati MC12
Old Enzo (item #25702 and 25703)
Max Schnell, will fit the front and rear tires (27404 and 30613)
Once installed all you need to do is sand the tire lightly to true it up and remove any convex or concave centers, and away you go. This can be done easily using a 120 grit garnet sand paper or emery board, then finish with a 240 or 480 grit.
A recommendation from Paul Gage:
If you wish to glue on the rear tires, use a clear nail polish. Just clean the tire with acetone, lightly sand the bead on the hub, paint a generous layer on the inside bead of the hub, paint the outside bead of the tire, then mount the tire. Allow one hour to dry, sand them true, and away you go!