SKU: PGT-21083XD PGT-21083XD Front Urethane Replacement Tires

$4.49

About Shipping

The table below reflects shipping charges to addresses in the Continental United States. We ship packages via UPS and the US Postal Service. We do ship internationally** please see note below.

The shipping charges for Ground Shipping* are based on the amount of your purchase as shown in the following table.

Sale Amount^*	0-$100	Over $100
Ground Shipping	8.99	13.99

Shipping for UPS Overnight, 2-Day, and 3-Day are based on weight and are computed automatically at checkout. Simply fill out the order form and before your order is submitted, you will be presented with all shipping options and costs.

Shipments outside the Continental United States will be re-billed to reflect the actual shipping rate.

Inventory: In-Stock

Qty

Description

PGT-21083XD Front Urethane Replacement Tires

This tire can be used as a replacement fronts for the following Carrera 132 Scale Cars:

'57 Chevy Fronts

Chevelle Fronts

Bel Air Fronts

Once installed all you need to do is sand the tire lightly to true it up and remove any convex or concave centers, and away you go. This can be done easily using a 120 grit garnet sand paper or emery board, then finish with a 240 or 480 grit. A recommendation from Paul Gage: If you wish to glue on the rear tires, use a clear nail polish. Just clean the tire with acetone, lightly sand the bead on the hub, paint a generous layer on the inside bead of the hub, paint the outside bead of the tire, then mount the tire. Allow one hour to dry, sand them true, and away you go!

PLEASE NOTE: These tuning tires will look much smaller than the Carrera stock tires you are replacing (in some cases you may even be able to fit the tuning tire, inside the stock tire). Some tuning tires may fit multiple wheels, these tires are made to stretch so Paul doesn't need to have a separate tire available for each type of car.

When installing you will need to stretch the tuning tire over the wheel.. To avoid damage to the car, or wheel, we have found it is easiest to take the chassis off by removing the 4 bottom screws prior to installation.